Online Educational Platform based on AI
Maintenance methods of clutch 1. Clutch pedal free-play should be checked and changed periodically. 2. Should check and adjust the gap in between clutch plate and pressure plate. (Note: gap should be 0.3 mm to 0.5 mm) 3. Clutch lining should be checked in periodically. If any problem finds, it should be cured. 4. Should […]
What is clutch Clutch is the first part of the transmission system. It is mounted between the engine and the gear box. Clutch is a mechanism that helps to rotate the rotation from a shaft to another shaft on the same axis. Used to change gears softly, to stop the vehicle and for Engine idle. […]
Basic components of Automobile 1. Frame 2. Engine 3. Clutch 4. Gear box 5. Propeller shaft 6. Rear axle 7. Front axle 8. Suspension system 9. Steering system 10. Braking system 11. Wheel and tyre and 12. The electrical system Important components of the automobile chassis The vehicle without the body is called as the […]
What is air resistance Air resistance On the road the blowing wind against the direction of the vehicle and the opposing force due to the vehicle speed oppose the vehicle to move front. This opposing force is called as the air resistance. To find the air resistance of a vehicle, the following formula can be […]
What is Automobile Transmission System In an automobile, engine is the main source for developing the power and the power produced from it must be transmitted to the wheels of the vehicle to move it from one place to another. The system which is developed for transmitting the power from the engine to the wheels […]
The market is flooded with cheap mobile charger circuit.every charger circuit is not same, some of them contains few extra capacitors or resistors. First you need to understand the basics of components. What is PCB board? A printed circuit board, or PCB, is used to mechanically support and electrically connect electronic components using conductive pathways, […]
What is stress? The internal resistance offered by a body per unit area against deformation is known as stress. The unit of stress is N/mm2orN/m2 When an external force acts on a body, the body tends to undergo deformation. Due to cohesion between molecules the body resist the force. This resistance offered by the body […]